코드 엠프 리모콘 설정 방법이라는데...
자세히 해석 좀 부탁드립니다.
(영어가 많이 딸려서...ㅠㅠ)
ATTENTION!
Chord Electronics have recently modified our pre-amplifier remote control software.
The remote control will now stop working after you replace the batteries until you reactivate the remote.
This can be done by following these simple instructions.
1) Press down and hold on the set button, a green led opposite will flash on then off and then will stay on, you can now let go of the set button (The set button can be located on the top left hand corner just below the word “PRE-AMP”).
2) Now press the following buttons on your remote control (They are all located in the top set of commands) TAPE2, DISC2, TAPE2 and then TAPE2 again (The green LED will flash with each button pressed it will turn off when the last TAPE2 is pressed).
3) Your PRE-AMP remote control should now be reactivated and ready to use.
|